Application of Heat Transfer Flex (MetaTex)
 

Reverse cut the film using a 45° blade. Once weeded, the product can be applied to the textile using a heat transfer press, applying pressure through the Polyester liner. Remove the liner immediately after pressing, when the film is still hot, and then press again for 2 seconds. Colours may overlaid. We recommend that you always perform a test on the textile first.

» Technical Data Sheet [pdf]
 
 
Temperature
Time
Pressure
Cotton
165 - 175°C
20 - 25 sec
High
Cotton / Polyester [Mix]
165 - 175°'C
20 - 25 sec
High
Polyester / Acrylic [Mix]
160 - 170°C
15 - 20 sec
Medium
 
Application of Heat Transfer Flex (MD-MX Digital)
 
Print the image, orientated the correct way round. Allow 24 hours before weeding, and pressing. Once weeded, apply MX application tape to lift the print. Use a heat transfer press, applying pressure through the application tape. Press first for 2 seconds, before removing the application tape, then covering the image with a silicone-release paper and pressing for 17 sec. It is recommended to test a sample print. Wash inside out.

» Technical Data Sheet [pdf]

 
 
Temperature
Time
Pressure
All
155 - 160°C
17 - 20 sec
Medium